Mounting The Current Clamp; Attaching The Compressed Air Hose - Abicor Binzel xFUME ADVANCED Manual De Instrucciones

®
xFUME ADVANCED

6.2 Mounting the current clamp

A current clamp is supplied with the device. A second current clamp is optionally available for the
connection of a second fume extraction torch.

6.3 Attaching the compressed air hose

From June 2021
6 Commissioning
Connect the current clamp cable to the current
1
clamp port.
Lay the current clamp over the cable assembly
2
and ensure that the red point on the current
clamp always points in the direction of the
current flow.
Switch the Auto/Manual switch to Auto on the
3
control panel.
Screw in the compressed air connection
1
including sealing ring.
Mount the compressed air hose on the
2
compressed air connector and connect to the
compressed air supply. Use a compressed air
hose with an inside diameter of a min. of 9 mm
and a max. length of 5 m.
EN - 13