®
xFUME
ADVANCED
12 Disposal
12.1 Disposing of welding dust
All welding dust collected must be disposed of in accordance with local regulations.
12.2 Disposing of materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labeled in preparation for their sorting and
separation for later recycling.
12.3 Disposing of consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
► Please observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the manufacturer of the consumables.
The disposal of dust collecting bags and disposal bags is subject to special waste regulations. The dust must
not enter sewage systems or be disposed of together with normal household waste.
► Observe the local and official regulations.
12.4 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
13 Warranty
This product is an original ABICOR BINZEL product. Alexander Binzel Schweisstechnik GmbH & Co. KG
guarantees correct manufacture and assumes a factory production and function warranty for this product
upon delivery, which is in line with the most current technology and the regulations in force. If
ABICOR BINZEL is responsible for a defect that is present, ABICOR BINZEL is obliged to remedy the defect
or deliver a replacement at its own cost and its own discretion. The warranty covers manufacturing faults,
but not damage resulting from natural wear and tear, overloading or improper use. The warranty period is
defined in the General Terms and Conditions. Exceptions in the case of specific products are regulated
separately. Warranty will also be rendered invalid if spare parts and wear parts are used that are not
original ABICOR BINZEL parts and if the product has been repaired improperly by the user or a third party.
Wearing parts are excluded in general from the warranty. In addition, ABICOR BINZEL is not liable for
damage caused by using our products. Questions about warranty and service can be addressed to the
manufacturer or our distributors. For more information, visit www.binzel-abicor.com.
From June 2021
Equipment marked with this symbol is covered by European Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE).
— Electrical and electronic equipment must not be disposed of with household waste.
— Electrical equipment must be disassembled prior to proper disposal.
11 Disassembly on page EN-22
— Components of electrical equipment must be collected separately and recycled in an
environmentally friendly manner.
► Observe the local regulations, laws, provisions, standards and guidelines.
► Contact your local authority for information about the collection and return of
electrical and electronic equipment.
12 Disposal
EN - 23