Harbor Breeze SPRINGFIELD II Manual Del Usuario página 15

FINAL INSTALLATION
4. Locate motor screws (M) and lock washers (O) that
were removed in Step 5 on page 8.
Insert two motor screws (M), along with lock
washers (O), through one blade arm (H) to attach
blade arm (H) to motor housing. Tighten motor
screws (M) securely. (Fig. 4) Repeat with remaining
blade arms (H), making sure to completely secure
each blade arm (H) before proceeding with the next.
5.
If you wish to USE the light kit, remove three light
kit fitter screws (S) from light kit fitter (F). (Fig. 5A)
Remove three switch housing screws (T) from switch
housing and remove switch housing cap (N). Locate
RED and WHITE wires in switch housing labeled
FOR LIGHT KIT CONNECTION and remove plastic
that holds these two wires together. (Fig. 5B)
Proceed to Step 6.
If you do NOT wish to use the light kit, attach pull
chain extension (K) to fan pull chain as described in
Step 10 on page 17 and installation is complete.
6. Connect WHITE wire from switch housing to WHITE
wire from light kit fitter (F). Connect RED wire from
switch housing to BLACK wire from light kit fitter (F).
Make sure that molex connections are secure. (Fig. 6)
15
4
O
5A
S
5B
T
White Wire
6
Switch
Housing
Molex
Connections
D
G
H
M
F
Switch
Housing
Red Wire
N
F