Important; Downrod Style Fan Mounting - Harbor Breeze SPRINGFIELD II Manual Del Usuario

INITIAL INSTALLATION
4. Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers
provided with the outlet box. (Fig. 4)
*NOTE: It is very important that you use the
proper hardware when installing the mounting
bracket (C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (M) and lock washers (O)
from underside of motor. [If there are plastic
motor blocks installed with the motor screws (M)
and lock washers (O), discard the plastic motor
blocks.] (Fig. 5)
Follow mounting instructions on pages 8 - 10 for
"Downrod Style Fan Mounting" or proceed to
pages 10 and 11 for "Closemount Style Fan
Mounting", depending on mounting method (A or
B) chosen in Step 2 on previous page.

DOWNROD STYLE FAN MOUNTING

1. Remove pin (Q) and clip (R) from motor housing
yoke at top of motor housing (D) and partially loosen
set screws. (Fig. 1)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer downrod
(not included) than the one provided. Angle style
mounting is best suited for angled or vaulted
ceilings. A longer downrod is sometimes necessary
to ensure proper blade clearance.
4
5
1
D
8
C
R
O
M
Set
Screw
Q