Final Installation - Harbor Breeze SPRINGFIELD II Manual Del Usuario

FINAL INSTALLATION

1. Temporarily lift canopy (B) to mounting bracket
(C) to determine which two canopy mounting
screws (P) in mounting bracket (C) align with
slotted holes in canopy (B) and partially loosen
these two canopy mounting screws (P).
Remove the other two canopy mounting screws
(P). Now, lift canopy (B) to mounting bracket
(C) again, aligning slotted holes in canopy (B)
with loosened canopy mounting screws (P) in
mounting bracket (C). Twist canopy (B) to lock.
Re-insert the two canopy mounting screws (P)
that were just removed and tighten all canopy
mounting screws (P) securely. (Fig. 1)
2.
Align the three blade screws (U), pre-installed on
the blade arm (H), with the three holes in the
blade (G). Press up on the blade arm (H) firmly so
that the blade screws (U) come through the holes
in the blade (G). Be careful not to use so much
force that the blade arm (H) bends. (Fig. 2)
Repeat for each blade arm (H).
3.
Place the plastic locking mechanism (E) on the
opposite side of the blade (G) as the blade arm
(H), refer to Fig. 2, with the narrower end of the
plastic locking mechanism (E) toward the end of
the blade (G) and against the blade arm screw
(U) as shown in Fig. 3. [Please note the side of
the plastic locking mechanism (E) indicating
THIS SIDE UP.] Rotate plastic locking
mechanism (E) to the left (counterclockwise) to
lock plastic locking mechanism (E) into place.
Repeat Step 3 for each blade (G).
1
2
H
U
3
U
14
P
P
B
E
G
G
E