Festo CPX-4AE-T Manual Del Usuario página 13

English
1 User instructions
CPX-analogue I/O modules are exclusively intended for
use in CPX terminals. Analogue I/O modules for CPX ter-
minals consist of an electronics module that is assembled
in an interlinking block of the CPX terminal along with a
combinable connection block.
The specified limits of the technical data must be complied
with during operation. For more detailed information, see the
description of the CPX analogue I/O module (P.BE-CPX-AX-...)
and the CPX system description (P.BE-CPX-SYS-...).
Warning
S Before carrying out installation and maintenance
work, switch off the following:
– Compressed air supply
– the operating and load voltage supply.
S Connect an earth wire with sufficient cable cross
section to the terminal marked with an earth symbol.
S The I/O modules contain electrostatically sensitive
devices. For this reason, do not touch any
components. Observe the handling specifications
for electrostatically sensitive devices.
Note
Only put a completely assembled and wired CPX
terminal into commission.
Festo CPX-AX-T 1107d English 13