Festo CPA−SC−DP Manual Del Usuario página 24

Fitting a new node
1
2
1.
Insert the plug of the ribbon cable.
2.
Place the field bus node on the terminal so that the
shoulder 1 comes to rest in the groove 2.
(viewed from below)
3.
Push the field bus node in the direction of the valves, so
that the plastic nose 3 fits completely into the recess.
4.
Screw in the screws with washers (position see
Removing") and tighten with 0.1 Nm (±10 %).
24
Contact plate The contact plate must not be
bent when the node is fitted.
2
Festo CPASC−DP 0610NH English
3