Troubleshooting - Bissell POWERFORCE HELIX TURBO REWIND PET 2692 Serie Guia Del Usuario

Clearing a Clog
1
Remove the hose from
the back of the vacuum
by twisting it to the left
(counter-clockwise).
Remove any debris that
may have gotten clogged.

Troubleshooting

WARNING
disconnect plug from electrical outlet before performing maintenance or troubleshooting checks.
Problem
Vacuum
cleaner
won't run
Vacuum
cleaner won't
pick up dirt
Cord won't
retract
10
www.BISSELL.com
2
Check the foot hose on
the back of your vacuum
down towards the bottom.
If necessary, remove the
screw from the foot hose
and check for clogs.
To reduce the risk of electric shock, turn Power Switch OFF and
Possible causes
Power cord is not plugged in.
Blown fuse/tripped breaker.
Dirt Tank is full.
Filter is dirty.
Hose is not secure.
Dirt Tank is not in place.
Vacuum path is clogged.
Rotating Brush Roll drive belt is
broken.
Drive belt is stretched.
Brush Roll bristles are worn.
Brush Roll is jammed.
Power Cord is knotted or twisted.
3
Check the air passageway
on the bottom of your
vacuum. Remove the
bottom cover and the
brush. Remove any debris.
Remedies
Check electrical plug.
Check/replace fuse or reset breaker.
Empty Dirt Tank.
Check filter and remove debris or
clean.
Check and make sure hose is
snapped into place at both ends.
Make sure Dirt Tank is completely
inserted and snapped into place.
Visually check air passageway, hose
inlet and hose for anything that
might be obstructing the vacuum
path. Carefully remove blockage.
Replace drive belt.
Check drive belt area and remove
obstructions. Replace drive belt if
necessary.
Replace Brush Roll.
Remove Brush Roll and clean debris
from brush and ends. Check drive
belt for any damage.
Follow instructions on page 6.