Yakima KingJoe Pro 2/3 Manual Del Usuario página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Attach top hooks.
Attach both top strap hooks (labeled TOP) around top edge of the trunk lid, hatch lid, or rear door.
They should be parallel, and no wider
than the body of the KingJoe Pro.
Route the straps over the KingJoe Pro
frame. If hooks do not fit into the edge
of the hatch or trunk, you can install
the Glass Hatch Hooks.
Remove hooks before
opening the hatch or
trunk. Opening the hatch
or trunk with hooks
installed could cause
damage to the vehicle.
WARNING: DO NOT ATTACH THE UPPER HOOKS TO GLASS, PLASTIC, OR SPOILERS! USE THE GLASS
HATCH ADAPTERS. USE OF THE GLASS HATCH ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
1033584C-3/30
Adjust straps by
pulling on free end of
straps, or by pressing
the release buttons on
Follow Glass Hatch Adapter installation instructions on page 5.
the buckles.
WARNING: Do not pull
upper straps sideways!

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kingjoe pro 2Kingjoe pro 38002624

Tabla de contenido