Attach bottom hooks.
Attach both bottom strap hooks (labeled BOTTOM).
Appropriate attachment points will depend on your
specific vehicle.
Acceptable attachment points may include the
bottom edge of the trunk, hatch lid, or rear door.
Additionally, the tie down hooks underneath the
vehicle or the metal ledge of the bumper are
acceptable. Only attach hooks to areas with
sufficient support.
Route the straps over the KingJoe
Pro frame as shown.
WARNING: DO NOT ATTACH THE LOWER HOOKS TO GLASS OR PLASTIC! USE THE GLASS HATCH
ADAPTERS. USE OF THE GLASS HATCH ADAPTERS WILL LIMIT THE LOAD TO TWO BIKES ONLY.
Attach side hooks.
Adjust straps as necessary to attach side
strap hooks (labeled SIDE) to upper side
edge of trunk, hatch, rear door, or above,
below, or next to the tail lights. Adjust
straps by pulling on free end of straps.
YES
NO!
Note: If it is difficult to
place the hook, insert in
a wider section and then
slide into place.
TIGHTEN ALL STRAPS COMPLETELY. DO NOT OVERTIGHTEN.
1033584C-4/30
Follow Glass Hatch Adapter installation instructions on page 6.
NO!
YES