Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TOP HOOKS: Glass Hatch Adapter installation instructions
A
Remove the
upper top strap
and top hooks.
B
OPEN THE
HATCH
DOOR.
C
D
CLOSE THE HATCH.
Pull firmly on the
straps to seat the pads.
Now that you've installed the glass hatch adapters continue to STEP 4.
If you need Glass Hatch Adapters to replace both top and bottom hook straps, see your
dealer, or go to www.yakima.com to purchase a second set of Glass Hatch Adapters.
1033584C-5/30
Confirmed your vehicle does not require
Glass Hatch Adapters? Skip this page.
Pass the Glass Hatch Adapter
strap ends through the hatch
opening from inside the vehicle.
BEFORE CLOSING
THE HATCH...
The pads must be free
from contact between
hatch door and
vehicle's frame.
Straps should be parallel
with the top buckles.
THREAd NEW STRAP-ENdS INTO KINGJOE PRO bUCKLES.
E
Keep the pads away
from the door's edge.
While supporting the carrier with
your body, attach the new straps to
your carrier's top buckles.
Adjust upper straps by pulling on the
ends TOWARD THE VEHICLE.
OK
Publicidad
Tabla de contenido
