Surtek HL720 Manual De Usuario Y Garantía página 14

WARNING: Never use products with bleach
or chlorine or any other corrosive materials,
including liquids containing solvents (i.E. Gas,
oils etc), trisodium phosphate products, ammo-
nia, or acid-based cleaners. These chemicals will
harm the unit and cause damage to the surface
being cleaned. Always read the label.
RECOMMENDATIONS FOR CLEANING
Turn on the water supply tap FULLY. Release the
safety catch, then press the trigger for a few
seconds to allow air to escape and to discharge
residual pressure in the pipes.
Dissolve dirt by applying detergent with the fan
jet to the dry surface. On vertical surfaces, work
from the bottom upwards.
Leave the detergent to act for 1 to 2 minutes,
but do not allow to dry out. Apply the high
pres- sure jet, keeping the nozzle at least 10"
(30cm) from the surface, working from the bot-
tom up- wards.
Avoid allowing the rinsing water to run on to
unwashed surfaces.
WARNING: Always test the spray in an area
free and clear of people and objects before you
spray at the intended cleaning surface.
WOOD AND VINYL DECKS
Rinse deck and surrounding area with fresh wa-
ter. If using detergent, fill the detergent reser-
voir and apply to the area being cleaned at low
pressure. For optimal results, reduce your work
area to smaller sections and clean each section
one at a time. Allow the detergent to rest on
the surface for a few minutes and then rinse
at high pressure. DO NOT LET THE CLEANSER
DRY. Always clean from left to right and top
to bottom for best results. Rinse at high pres-
sure using the fan spray keeping the tip of the
spray nozzle at least 6-9 inches from the clean-
ing surface. Maintain a further distance from
the cleaning area when using a direct spray.
Caution: For softer woods, increase the distance
from the cleaning area.
CEMENT,PATIOS,STONE,AND BRICK
Rinse cleaning and surrounding area with fresh
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. Rinse at high pressure using
the fan spray in a sweeping motion keeping
the tip of the spray nozzle at least 3-6 inches
from the cleaning surface. Maintain a further
distance from the cleaning area when using a
direct spray.
14
CARS,BOATS,AND MOTORCYCLES
Rinse cleaning and surrounding area with fresh
water. If using detergent, fill the detergent res-
ervoir and apply to the area being cleaned at
low pressure. To achieve the best results, clean
one side at a time. Allow the detergent to rest
on the surface for a few minutes, but do not let
the detergent dry. Rinse at high pressure using
the fan spray in a sweeping motion keeping the
tip of the spray nozzle at least 8 inches from the
cleaning surface. Maintain a further distance
from the cleaning area when using a direct
spray. Wipe surface dry for a polished finish
IMPORTANT: Only use liquid detergent, DO
NOT use regular detergent.
BARBECUE GRILLS, POWER EQUIPMENT, AND
GARDEN TOOLS
Rinse cleaning and surrounding area with fresh
water. If using detergent, fill the detergent
reservoir and apply to the area being cleaned
at low pressure. Allow the detergent to rest on
the surface for a few minutes, but do not let the
detergent dry. Rinse at high pressure using the
fan spray keeping the tip of the spray nozzle at
least 1-3 inches from the cleaning surface. Main-
tain a further distance from the cleaning area
when using a direct spray.
CHECKING THE WATER FLOW
It is important connecting your machine to a
water faucet that supplies the necessary water
flow for its operation, otherwise you could lose
your warranty.
To know the flow of your water line, follow
these instructions:
Get:
1.19 liters capacity container.
2. Chronometer.
How to do:
1. Place the container below the water faucet.
Open the water tap and count the time until the
container is filled up.
2. Divide the 19 liters over the time it takes to
filled up.
NOTE: 1 second = 0.017 min
Examples:
1: The container was filled up in 2 minutes with
34 seconds. Divide 19/ 2.56 = 7.42 L/min
Your water flow is 7.42 L/min!