Casada BIO VITAL Manual Del Usuario página 17

STARTING-UP THE DEVICE
PREPARING THE TREATMENT
1. Please remove the device and the accessories from the packaging and check that are parts are there.
2. Connect the electrode [6], arm belt
power supply.
3. The zinc electrode is placed in the centre of the foot tub, which is connected to the Bio Vital control
device. The bath is filled with warm tap water to a maximum heat of 38°C until it comes up to the mark
of the inner sidewall of the tube.
4. Now add a measuring spoon of the special salt for one treatment into the water. By adding the salt, the
ampere value increases and so the conductivity of the water. Please make sure that the ampere value
is in the range between 0.5-2.0A (ideal value 1.0A). Increasing this value created a more intensive treat-
ment. The treatment can start once the electrolysis salt has dissolved.
Attention: Please reduce the salt content if the device switches off prematurely.
5. Now place the arm belt around your left or right hand and position your bare feet in the filled tub and
start the selected program.
Attention: Please ensure that the metal induction field of the arm belt is well moistened before
positioning it tightly.
heat belt
[5] and mains plug
electrode
mains plug
[4] to the device and connect the device to the
tens
arm belt
on/off
17 17