Festo CPX Serie Manual De Instrucciones página 19

Fitting the I/O module:
1. Only in cases where the electronic module has been
removed: Press the electronic module carefully into
the manifold sub-base.
2. Check the seal and sealing surfaces and refit the sub-
base.
3. Place the screws so that the self-cutting threads are
used. Tighten the screws by hand in diagonally oppo-
site sequence. Tightening torque 0.9...1.1 Nm.
3.3 Installation
Sensors and actuators can be connected to the I/O mod-
ules depending on the sub-base used.
Please note
When connecting the sensors and actuators, note the
instructions in the manual "CPX I/O modules and pneu-
matic interfaces."
Festo CPX-EA 0201NH English 19