Transporting/Tipping Of The Unit; Using The Flexpower™ Switch; Starting Pull Start Engines - Generac iX Serie El Manual Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Disc Sander (9")
Edge Trimmer
Electric Blanket
Electric Nail Gun
Electric Range (per element)
Electric Skillet
*Freezer
*Furnace Fan (3/5 HP)
*Garage Door Opener
Hair Dryer
Hand Drill
Hedge Trimmer
Impact Wrench
Iron
*Jet Pump
Lawn Mower
Light Bulb
Microwave Oven
*Milk Cooler
Oil Burner on Furnace
Oil Fired Space Heater (140,000
Btu)
Oil Fired Space Heater (85,000 Btu)
Oil Fired Space Heater (30,000 Btu)
*Paint Sprayer, Airless (1/3 HP)
Paint Sprayer, Airless (hand-held)
Radio
*Refrigerator
Slow Cooker
*Submersible Pump (1-1/2 HP)
*Submersible Pump (1 HP)
*Submersible Pump (1/2 HP)
*Sump Pump
*Table Saw (10")
Television
Toaster
Weed Trimmer
* Allow 3 times the listed watts for starting these
devices.

Transporting/Tipping of the Unit

Do not operate, store or transport the unit at
an angle greater than 15 degrees.
Owner's Manual for Portable Generator
Using the FlexPower™ Switch
1200
When the accessories connected to the gen-
500
erator are going to be used intermittently
400
(such as a hand drill), the FlexPower™ switch
can be pushed to the ON (I) position. This will
1200
lower generator engine speed when loads are
1500
not being applied, saving fuel, reducing
engine wear and extending runtime.
1250
700

Starting Pull Start Engines

875
500 to 750
1200
250 to 1100
450
500
1200
800
1200
100
1. Unplug all electrical loads from the unit's
700 to 1000
2. Place generator on a level surface.
1100
3. Turn the FlexPower Switch OFF (O).
300
4. Turn fuel valve to the ON. See
400
225
150
600
150
50 to 200
700
200
2800
5. Press primer bulb (up to six (6) times). See
2000
1500
800 to 1050
1750 to 2000
200 to 500
1000 to 1650
500
6. Slide engine choke to Full Choke position
WARNING
Recoil Hazard. Recoil could retract unexpectedly.
Kickback could result in death or serious injury.
CAUTION
Equipment and property damage. Disconnect electrical
loads prior to starting or stopping unit. Failure to do so
could result in equipment and property damage.
receptacles before starting engine.
Figure 3-6.Fuel Valve ON
Figure
3-7.
Figure 3-7.Primer Bulb
(right). See
Figure
(000183)
(000136)
Figure
000725
000726
3-8.
3-6.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido