KTM Power Parts 45212948044 Instrucciones Para El Montaje página 9

1
1
5
3
4
4
B
D
- Turn the carburetor by 180°.
- Remove the screws (1) of the float chamber.
2
- Remove the main jet (2) and mount main jet 55 (included) (3 Nm).
- Position the float chamber and mount the screws (1) (2 Nm).
- Reassemble the throttle cable wire and throttle slide.
NOTE:
Order of parts, see Figure A.
(5) Throttle slide cover (scope of delivery)
(3) Throttle slide spring
(4) Spring retainer
(6) Throttle slide with jet needle
6
A
- Slide the throttle slide cover (5) (included) and throttle slide spring (3)
onto the throttle cable wire.
- Pull back the throttle slide spring and mount the spring retainer (4).
- Pull back the spring retainer (Figures B and C).
C
- Position the jet needle in the throttle slide.
- Mount the throttle slide with the jet needle (Figures D and E).
7
Ensure that the pin (7) of the spring retainer is engaged in the hole of the
throttle slide. Otherwise, there is a danger of the throttle cable wire coming
loose.
7
E
9