Required Accessories And Tools; Supplied Accessories; Optional Accessories; Other Required Accessories - Thermador T18 Serie Instrucciones De Instalación

Required accessories and tools

Supplied accessories

Installation instructions

Operating instructions

Installation kit


Optional accessories

Sealing Kit for Side-by-Side Installation BSEALKIT10
For permanent connection of two individual appliances,
e.g. Freezer next to Refrigerator.
Freedom Heater Kit for Side-by-Side Installation
XHEATKIT10
If the gap between the appliances is less
than 6" (160 mm).
Panel unification part (Metal strip) FPCONNTS10
For connection of two door panels. Can be used
for standard height door panels without further
preliminary work.

Other required accessories

Ice maker installation kit
For connecting appliances which require water,
e.g. for an ice maker.
Maximum outer diameter of the water pipe
13
(without fittings): / " (10 mm).
32

Miscellaneous

Stepladder

Dolly, hand truck

Hammer drill for drilling holes in wall or floor

Bits according suitable for material and in different

sizes
Wooden beam (cross section min. 3" x 4") as an

alternative tip protection, length according to the
width of the installation niche
Wooden screws in different sizes

Thin plywood sheet, particle board or cardboard to

protect the floor from damage
Suitable material for covering and protecting

furniture (e.g. protective sheets)
Adhesive tape

Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
10
1
/ " OD copper line
4

Tools

Cordless screwdriver
Torx bit T20 + magnetic
holder
Torx screwdriver T20
5
/ " (8 mm) hex nut driver
16
Wood drills in different sizes
1
Open end wrench / "
2
(SW 13 mm)
Multigrip pliers
Adjustable wrench
Cutter with adjustable blade
Metal tape measure,
folding rule
Square
Level, length 2' (60 cm) and
4' (1,2 m)
Level, min. 4' (1 ,2 m) long