Care And Cleaning - Kohler STERLING 442007-U Guia De Instalacion

Install the Lavatory (cont.)
Install the faucet to the countertop according to the faucet
manufacturer's instructions.
Install the drain to the lavatory according to the drain
manufacturer's instructions.
NOTE: Do not use adhesives or adhesive sealants.
CAUTION: Risk of personal injury or product damage.
Vitreous china can break or chip if the product is handled
carelessly. Handle with care.
CAUTION: Risk of product damage. Overtightening the nuts
may cause irreparable damage to the lavatory. Do not
overtighten the nuts.
Apply a continuous bead of quality sealant to the top surface of
the lavatory rim where it will contact the countertop.
For wood, wood composite, and marble countertops, install the
lavatory to the countertop with the clamps and screws provided.
For other countertop materials, refer to the countertop
manufacturer's instructions for recommended fasteners.
Position the lavatory evenly under the cutout before tightening
the clamps. Draw the lavatory rim up against the countertop until
it is snug. Do not overtighten.
Immediately wipe away any excess sealant, and fill any voids as
needed.
Allow the sealant to set for 30 minutes before proceeding.
Connect and tighten the trap to the drain, and complete the water
supply connections to the faucet according to the instructions
packed with the faucet.
Run water into the lavatory and check for leaks.
Clean up with a non-abrasive cleaner.

Care and Cleaning

For best results, keep the following in mind when caring for your
STERLING product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
Sterling 5 1084868-2-A