Operation; Manual Operation - Klarstein 10032725 Manual Del Usuario

OPERATION

Manual operation

The On/Off switch is must be switched to 'I' to begin operating the fire.Operation is via
by the buttons located on the left hand side of the fire under the canopy. The fire will
beep to indicate that it is powered up.
• Turn on the appliance by pressing the power switch on the main unit.
• To activate the flame effect, press the Flame button. The indicator light will
illuminate, this can be activated without the heater operating.
1 press: low brightness
2 or 3 presses: increase brightness
4 presses: switch the flame effect off
• The fan heater has two separate settings that are selected by pressing each function
button:
Button 1: 1000 W:
Button 2: 2000 W
To turn the heater off press the function button again and set the power switch to 0.
Remote control
Press once to turn the appliance and flame effects on. Pressing again
turns the appliance and flame effects off.
Press to cycle through the three flame effect settings.
Time calibration settings. If not set the timer effect will start from 0:00.
Week: Press
Press
Hour: Confirm with
Minute:Select
Conform with
Timer setting: You can set two time periods and temperature:
First timer period setting. Press
Hours: Press
Minutes: Select minutes with
Timer off setting: Repeat as timer on.
Press
the temperature.
Second timer: Repeat the setting prodedures for the first timer.
Press once to reduce the light brightness. Pressing again turns the light
off.
to choose the week. Confirm with
to choose the hour.
.
to set the minutes.
.
, the first timer o.
to set the hours. Press
. Confirm minutes with
to select the temperature. Press
.
to confimn hours.
.
to confimn
EN
21