Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
12. Complete the Installation
Caulk the joints between the receptor and the walls along with the vertical joint between the two
walls.
Allow to dry according to the sealant manufacturer's instructions.
Install any extra grab bars or towel bars to the bridging that was installed earlier. Follow the
accessory manufacturer's instructions.
Install the shower door according to the manufacturer's instructions.
13. Clean-Up
Consult the care and cleaning directions in the Homeowners Guide before cleaning the unit.
When cleaning up after installation, do not use abrasive cleansers, as they might scratch and dull
the product surface.
Remove stubborn stains, paint, or tar with turpentine or paint thinner.
Do not allow cleaners containing petroleum distillates to remain in contact with the product surfaces
for any length of time.
Remove plaster by scraping the surface with a wood edge. Do not use metal or wire tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to the residual plaster.
Kohler Co.
11
1024937-2-C
Publicidad
Tabla de contenido
