DJI RONIN 2 Guia Del Usuario página 3

Disclaimer and Warning
Congratulations on purchasing your new DJI OSMO
this document affects your safety and your legal rights and responsibilities. Read
this entire document carefully to ensure proper configuration before use. Failure to
read and follow instructions and warnings in this document may result in serious
injury to yourself or others, damage to your DJI OSMO product, or damage to other
objects in the vicinity. This document and all other collateral documents are subject
to change at the sole discretion of DJI OSMO.
By using this product, you hereby signify that you have read this disclaimer and
warning carefully and that you understand and agree to abide by the terms and
conditions herein. You agree that you are solely responsible for your own conduct
while using this product, and for any consequences thereof. You agree to use this
product only for purposes that are proper and in accordance with all applicable
laws, rules, and regulations, and all terms, precautions, practices, policies and
guidelines DJI OSMO has made and may make available.
DJI OSMO accepts no liability for damage, injury or any legal responsibility incurred
directly or indirectly from the use of this product. The user shall observe safe and
lawful practices including, but not limited to, those set forth in this document.
Notwithstanding above, your statutory rights under applicable national legislation
are not affected by this disclaimer.
OSMO is a trademark of SZ DJI OSMO TECHNOLOGY CO., LTD. (abbreviated as "DJI
OSMO") and its affiliated companies. Names of products, brands, etc., appearing
in this document are trademarks or registered trademarks of their respective owner
companies. This product and document are copyrighted by DJI OSMO with all rights
reserved. No part of this product or document shall be reproduced in any form without
prior written consent of or authorization from DJI OSMO.
Introduction
Mount the Top Accessory Mounting Plate and Camera Top Cross Bar to the top of the
camera to attach it to the RONIN
holes can be used to mount other accessories.
Usage
Mounting to a Blackmagic Camera
The included hot shoe plate should be used if using one of the following Blackmagic
cameras: Blackmagic Micro Cinema Camera, Blackmagic Pocket Cinema Camera 4K,
Blackmagic URSA Mini, and Blackmagic URSA Broadcast.
1. Slide the top accessory mounting plate into the hot shoe plate and adjust the position.
Then tighten the two screws in the middle part using a 3 mm hex key to secure the
mounting plate.
2
TM 2 gimbal. The mounting plate's 1/4"-20 mounting
product. The information in
TM