Handling Rules - Franke Smart FHR 604 C T BK Manual De Instalación Y Servicio

FHR 604 C T BK / FHR 604 C T XS / FHR 604 C T WH
Error code Error description
ER 03 &
Constant use of buttons;
continuous
control unit is disrupted
signal
after 10 seconds.
sound
ER 20
Flash fault.
ER 21
Excessive temperature.
Key evaluation fault.
ER 22
Control unit is turned
after 3.5 – 7.5 seconds.
Configuration data is
ER 31
incorrect.
Temperature sensor
ER 36
error.
Power supply is too low
ER 40
to turn on the appliance.
Communication error
between the electronic
ER 47
board configuration and
the heaters.
U 400
Incorrect connection.
WARNING: If the device is operated at maximum level for too long, it can turn off automatically.
This is an ordinary measure for safety of the device

Handling rules

Z Z
Handle and transport in the original
packaging.
Z Z
Pay maximum attention to the appliance
while loading/undloading and handling.
Z Z
Make sure that the packaging is securely
closed during handling and transportation.
Z Z
Protect the appliance from external factors
(such as humidity, water, etc.) that may
damage the packaging.
Z Z
Be careful not to damage the appliance
due to bumps, crashes, drops, etc. while
handling and transporting and not to break
or deform it during operation.
Potential cause for error
Water or cooking utensils
on the glass over the
control unit.
^ C error.
The ambient temperature
for electronics is too high.
Short circuit or error in
detection of keys.
---
Short circuit or electronic
board turns off.
Primary PTC is too hot.
No communication or
faulty communication.
Control unit is connected
incorrectly.
– 17 –
Clearing error
Clean the operating
surface of the hob.
Replace the electroni
board.
Allow the cooking surface
to cool down. Check the
temperature verification
of the control unit.
Replace the electronic
board.
New configuration is
required.
Replace the electronic
board.
Disconnect the hob from
power supply system.
Make sure that the
connection cable is
connected correctly and
functionally.
Connect the stove to
correct mains voltage.
EN