Child-Proof Lock; Maintenance And Cleaning; Detergent Drawer - Beko WMD 57122 Manual Del Usuario

Starting the Program
1. Press "Start/Pause/Cancel" button to
start the program.
2. Program follow-up lamp showing the
startup of the program will light up.
Progress of program
Progress of a running program is shown through
the program follow-up indicator. At the beginning
of every program step, the relevant indicator
lamp will light up. The indicator that is lit up at
the bottom of the series of symbols indicates the
step that is being carried out.
C
If the machine is not spinning, the
program may be in rinse hold mode or
the automatic spin correction system
has been activated due to an excessive
unbalanced distribution of laundry in the
machine.
Changing the selections after the
program has started
Turning the program knob while the program is in
a normal flow will not change the program.
Switching the machine to standby mode
Press "Start/Pause/Cancel" button momentarily
to switch your machine to the standby mode.
"Pause" lamp (II) will light up to indicate that the
machine is switched to standby mode.
Selecting or canceling an auxiliary
function in standby mode
Auxiliary functions can be cancelled or selected in
accordance with the step the program is at.
Adding/removing laundry in standby
mode
The door can be opened if the water level is
suitable. Laundry may be added / taken out by
opening the door.

Child-proof lock

You can protect your machine from being
tampered by children by means of the child-proof
lock. In this case, no change can be made in the
running program.
The machine is switched to child-lock by
pressing the 2nd and 4th auxiliary functions
from top for 3 sec. "CL" (Child lock is activated)
label appears on the screen. The same symbol
will also be displayed whenever any button is
pressed while the machine is child-locked.
Lamp of the first auxiliary function from the top
will flash when the child-proof lock is activated.
To deactivate the child-proof lock, press the 2nd
and 4th auxiliary function buttons for 3 sec. "CL"
(Child-proof lock is deactivated) label appears
on the screen. Lamp of the auxiliary function will
fade if it is not selected when the child-proof lock
is deactivated.
Ending the program through
canceling
"Start/Pause/Cancel" button is pressed for 3
seconds to cancel the program.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon
in the softener compartment and pull
towards you until the compartment is
removed from the machine.
C
If more than a normal amount of water
and softener mixture starts to gather in
the softener compartment, the siphon
must be cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water in a
washbasin.
3. Replace the drawer into its housing after
cleaning. Check if the siphon is in its
original location.
Inlet water filters
There is a filter at the end of each water intake
valve at the back side of the machine and also at
the end of each water intake hose where they are
connected to the tap. These filters prevent the
foreign substances and dirt in the water to enter
into the machine. Filters should be cleaned as
they get dirty.
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with an
appropriate brush.
• If the filters are very dirty, you can pull
them out by means of pliers and clean
them.
9 - EN