Kohler K-5805 Guia De Instalacion página 5

Nut
Rail
Bolt
2. Install the Optional Undermounter Kit
NOTE: This cast iron sink requires either an undermounter kit or
support framing. Undermounter kit installation is covered in this
section. Support framing is covered in the "Install the Support
Frame" section.
IMPORTANT! Installing a support frame is required for K-6498 and
K-6499 models, and is an installation option for all other models. If
applicable, proceed to the "Install the Support Frame" section.
Determine the front-to-back length of the inside of the cabinet.
If necessary, cut the rails so they fit snugly with the cabinet walls.
Rails may be up to 1/8" (3 mm) shorter than the determined
length of the inside of the cabinet.
Thread the bolts into the nuts two turns, and then slide the nuts
into the slot in the rails. Slide the nut and bolt into the desired
position in the slots located on the rails. Adjusting bolts should be
located in the outermost slots that will be under the corners of
the sink.
With a tape measure, determine the overall width of your sink.
This distance represents the distance (A) between the outside
edges of the rails, as shown in the schematic above.
Using a hanger bracket as a template, mark the screw placement
on the cabinet, according to the measured width of your sink.
Drill 1/8" (3 mm) starter holes at the marks.
Proceed to the "Install the Sink" section.
Kohler Co.
Hanger
Bracket
Rails
A
Front of Cabinet
5
Bolt
Rail
1007262-2-G