Publicidad
Step 11
Fasten three ANGLE BRACKETS (X) to the FRONT
å
MOLDING (L). Use three BLACK 9/16" LARGE
HEAD SCREWS (II).
Fasten the TOP MOLDING (P) to the FRONT MOLDING (L).
å
Use three BLACK 9/16" LARGE HEAD SCREWS (II).
NOTE: There are no pre-drilled holes in the TOP
å
MOLDING (P). The SCREWS will tighten into the grooves.
BLACK 9/16" LARGE HEAD SCREW
(6 used in this step)
Page 16
II
401902
(3 used)
P
L
Groove
www.sauder.com/services
X
Publicidad
