Armrests; Armrest Adjustment; Backrest Adjustment - Grammer PRIMO Professional S Manual Del Usario

-
* if fitted ** depending on model
GB
983
+
984
*** optional extra
Seat functions and operation

Armrests

The armrests can be folded back if required and
the height individually adjusted.
To adjust the armrests for height, separate the
round cap (see arrow) from the cover, loosen
the hexagon nut (size 13 mm) behind it and
adjust the armrests to the desired position (5-
steps) and tighten the nut
again (25Nm). Replace the cap onto the nut.
WARNING:
If the belt roller is fitted, do not install the
armrest in the lowest position as otherwise the
belt roller might not function correctly.
Carry out a functional test of the belt roller.

Armrest adjustment

The inclination of the armrests can be modified
by turning the adjustment knob.
When turning the knob to the outside (+) the
front part of the armrest will be lifted, when
turning the knob to inside (-) it will be lowered.

Backrest adjustment **

Pull up the locking lever to release the backrest
catch.
For seats with narrow seat cushions, a loop
should be pulled upwards to unlock the
backrest.
When releasing the backrest catch, do not apply
load to the backrest by pressing against it.
By exerting pressure on or off the front or rear
part of the seat pan it can be moved to the
desired position. Release the locking lever to
lock the backrest.
It should not be possible to move the
backrest into another position after it has been
locked.
23