Maintenance And Storage - KRATOS SAFETY LIFT RES-Q FA 70 201 00 Manual Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
not necessary to proceed with the annual inspection.
After a max. cumulative length of 7500 m, the rope has to be changed. If the rope does not seem safe anymore, send the device
to KRATOS SAFETY or a competent person to check and replace the rope.
The product data sheet should be completed (in writing) after each periodic verification. The date of inspection and date of the
next inspection must be indicated on the data sheet. It is also recommended to put the date of the next inspection on the product.
If you use this product in very harsh environments (extreme weather and use conditions, heavy descents and liftings) you have to
check this product more often.
MAINTENANCE AND STORAGE: (These instructions must be strictly observed)
Clean the metal parts with a wet towel. Never tumble-dry, never let it dry in the sun or over a heat source. Air-dry
this product in an airy, shaded place. When drying this product, always put it with the brake drums upwards to avoid
humidity in the housing. Rinse the rope with warm water and wipe it with a dry towel afterwards. Never disinfect the rope. Never
use chemical detergents, nor bleach. Disinfection of this product is prohibited. In case of contamination, retire this product envi-
ronmentally-friendly.
During transportation, keep the equipment away from any cutting edges and in its packaging. Store the rope loosely in figure of
eight loops to avoid knots, which may result in blocking the device.
Repairs may only be effected by KRATOS SAFETY or a competent person. Repairs, adjustments or changes to this product that have
not been authorized by KRATOS SAFETY can lead to severe accidents and falls. Changes (e.g. longer rope) and repairs have to be
performed by KRATOS SAFETY only or a competent person.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido