EGO PSX2500 Manual Del Operador página 18

FILLING OIL TANK WITH BAR AND
CHAIN LUBRICANT (Fig. 3)
WARNING:
starting that could cause serious
personal injury, always remove the
battery pack from the tool before filling
the tank with oil.
WARNING:
bring any fire or flame near the oil or
the pole saw.
NOTICE:
The pole saw is not filled with oil at the time of purchase. It is essential to fill
the tank with chain oil before use. Operating the pole saw without chain oil or when the
oil level is below a certain amount will result in damage to the pole saw. Chain life and
cutting capacity depend on optimum lubrication. The chain is automatically lubricated
with chain oil during operation, if there is sufficient oil in the reservoir. Oil level should
also be checked after every 20 minutes of use and refilled as needed.
1. Remove the battery pack from the power pole.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the
oil tank.
3. Place the pole saw attachment upright to ensure that the tank cap is facing
upwards. Rotate the oil-tank cap counterclockwise to remove it.
4. Carefully pour the bar and chain oil into the tank until it fills to the tank neck. Be
careful not to let the oil spill from the opening. Wipe off any excess oil and close
the oil tank cap.
NOTE:
The oil flow ratio could be adjusted by turning the adjusting screw–
counterclockwise to increase the oil output, clockwise to decrease the oil output.
NOTICE:
◾
Never use oil or other lubricants not specifically designed for use on the bar and
chain. This can lead to a clogged oil system, which may cause premature wear of
the bar and chain.
◾
Check the oil level frequently and refill as needed.
◾
Do not use dirty, used or otherwise contaminated lubricants. Damage may occur
to the bar or chain.
18
POLE SAW ATTACHMENT — PSX2500/PSX2500-FC
To prevent accidental
Do not smoke or
3
Oil-tank Cap
Adjusting Screw