EGO PSX2500 Manual Del Operador página 24

Disassembling the Worn Bar and Chain (Fig. 9)
1. Switch off the tool and remove the battery.
2. Position the pole saw attachment on its side on a firm, flat surface, so that the
chain-sprocket cover is facing upwards.
3. Wear gloves. Using the combi-wrench provided with the power pole, loosen the
cover nut COUNTERCLOCKWISE and remove it from the chain-sprocket cover.
4. Remove the chain-sprocket cover from the pole saw attachment. Clean the chain-
sprocket cover with a dry cloth.
5. Remove the bar and chain from the mounting surface. Remove the worn chain
from the bar.
9
Cover Nut
NOTICE:
If there is difficulty in removing the bar and chain from the mounting surface,
place the pole saw upright, with one hand support the bar, to loosen the tensioning
screw CLOCKWISE with the other hand and then remove the bar with the chain.
NOTICE:
This is a good time to inspect the drive sprocket for excessive wear or
damage.
24
POLE SAW ATTACHMENT — PSX2500/PSX2500-FC
Chain-tensioning Screw
Chain-sprocket Cover
Sprocket