Setting The Alarm; Setting The Clock - Lenco CR-525 Manual De Usuario

Operating the PLL Radio
1. Press the "ON" or "OFF" button to turn the clock's radio/USB function on or off.
2. Multi press the "ON" button to switch between RADIO and USB (if inserted). Select Radio (clock display will
show the radio frequency).
3. Adjust the "TU+" or "TU-" to select the desired station.
4. Press the "VOL +" or "VOL -" button to adjust the volume.
5. Long press the "M+" button to store your desired station. The display will show the "P01" and then press M+
button to save on the first pre-set. If it displays "P02" this means the station is saved in the second preset by
default, but you can change the preset number with the "HOUR" and "MINUTE" buttons.
NOTE: you can store up to 10 preset channels.

Setting the Alarm

1. You must switch off the radio before you set the alarm time.
2. Press and hold the "ALARM" button until the time display starts to blink.
3. Now you can set the alarm time by short pressing the "HOUR" button to adjust the hour and pressing the
"MINUTE" button to adjust the Minute.
4. Press the "ALARM" button again now to confirm the alarm time.
5. Now select the wake up sound, buzzer
NOTE: if usb is selected but no usb memory stick is inserted when the alarm is triggered, the wakeup sound
will automatically change to buzzer.
Canceling the Daily Alarm
When the alarm is triggered press the "ALARM OFF" button to stop the alarm for 24 hours. The alarm will be
triggered again 24 hours later.
Turning off the Alarm
Short press the "ALARM" button until, the display will show no
alarm setting is OFF. No alarm will be triggered.

Setting the Clock

1. You must switch off the radio before you can set the clock time.
2. Press and hold the "TIME SET" button until the display begins to blink, and then release the button.
3. Press the "HOUR" and "MINUTE" button to adjust the hour and minute.
4. Press the "TIME PRE" button to store time.
/radio or usb
7
by short pressing the "ALARM" button.
, or symbols which means the