Fuel Safety; Safety Instructions For Maintenance - Husqvarna 122C Manual Del Usuario

Ocultar thumbs Ver también para 122C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The performance of the cutting attachment
increases.
The life of the cutting attachment increases.
The risk of accidents decreases.
Only use an approved cutting attachment guard.
Refer to
Accessories on page 19 .
Do not use a damaged cutting attachment.

Fuel safety

WARNING: Read the warning instructions
that follow before you use the product.
Do not mix the fuel indoor or near a heat source.
Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and let
the product dry. Remove unwanted fuel from the
product.
If you spill fuel on your clothing, change clothing
immediately.
Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use a soap and water to
remove the fuel.
Do not start the engine if you spill oil or fuel on the
product or on your body.
Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is a sufficient airflow.
Do not smoke near the fuel or the engine.
Do not put warm objects near the fuel or the engine.
Do not add the fuel when the engine is on.
Make sure that the engine is cool before you refuel.
Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
Do not add fuel to the engine in an indoor area. Not
sufficient airflow can cause injury or death because
of asphyxiation or carbon monoxide.
Tighten the fuel tank cap carefully or a fire can
occur.
Move the product at a minimum of 3 m (10 ft) from
the position where you filled the tank before a start.
Do not put too much fuel in the fuel tank.
Make sure that a leak cannot occur when you move
the product or fuel container.
Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
8
sure that the storage area does not contain an open
flame.
Only use approved containers when you move the
fuel or put the fuel into storage.
Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
Clean the product before long-term storage.
Remove the spark plug cap before you put the
product into storage to make sure that the engine
does not start accidentally.

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
Stop the engine, make sure that the cutting
attachment stops and let the product cool down
before you do the maintenance.
Disconnect the spark plug cap before you do the
maintenance.
The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas that can cause death. Do not run the
product indoors or in closed spaces.
The exhaust fumes from the engine are hot and can
contain sparks. Do not run the product indoors or
near flammable material.
Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use original accessories.
If the maintenance is not done correctly and
regularly, there is an increased risk of injury and
damage to the product.
Only do the maintenance as this operator's manual
recommends. Let an approved Husqvarna service
agent do all other servicing.
Let an approved Husqvarna service agent do
servicing on the product regularly.
Replace damaged, worn or broken parts.
Refer to the instructions for the cutting attachment
for correct procedure to install the trimmer cord and
correct cord diameter.
Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
1059 - 002 - 10.10.2019

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

122lk

Tabla de contenido