Cutting Attachment - Husqvarna 122C Manual Del Usuario

Ocultar thumbs Ver también para 122C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING: If the blades move when the
throttle trigger is in the idle position, then
the carburetor idle speed must be
adjusted. Refer to
speed on page 14 .
To do a check of the stop switch
1. Start the engine.
1059 - 002 - 10.10.2019
A
To adjust the idle
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the cutting attachment guard
The cutting attachment guard stops objects that ejects in
the direction of the operator. It also prevents injuries that
occur if you touch the cutting attachment.
1. Stop the engine.
2. Do a visual check for damages, for example cracks.
3. Replace the cutting attachment guard if it is
damaged.
Muffler
Do not use an engine with a damaged muffler. A
damaged muffler increases the noise level and the
risk of fire. Keep a fire extinguisher near.
Examine regularly that the muffler is attached to the
product.
Do not touch the engine or the muffler when then
engine is on. Do not touch the engine or the muffler
for a while after the engine stops. Hot surfaces can
cause injuries.
A hot muffler can cause a fire. Be careful, if you use
the product near flammable liquids or fumes.
Do not touch the parts in the muffler, if the muffler is
damaged. The parts can contain some carcinogenic
chemicals.

Cutting attachment

WARNING: Read the warning instructions
that follow before you use the product.
Do the regular maintenance. Let an approved
service center regularly examine the cutting
attachment to do adjustments or repairs.
7

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

122lk

Tabla de contenido