To operate the product
1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 32)
WARNING: Make sure that the front of
the cutting equipment does not touch the
ground.
2. Hold the product near your body for a stable work
position.
3. Be careful and operate the product slowly.
To use the SavE function
This product has a power saving function, SavE.
Note: The SavE function does not decrease the cutting
power of the product.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.
Maintenance
Clean the external parts of the product.
Examine that the start and stop switch works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Make sure that the cutter blade and cutter guard have no cracks and that they
are not damaged. Replace the cutter blade or the cutter guard if they have
cracks or if they have been exposed to impact.
Replace the cutter blade if it is bent or damaged.
Make sure that the hand guard is not damaged. Replace the guard if it is dam-
aged.
Make sure that the screws and nuts are tight.
Make sure that the battery is not damaged.
Make sure that the battery is charged.
Make sure that the battery charger is not damaged.
1175 - 001 - 08.07.2019
1. Press the SavE button on the keypad.
2. Make sure that the green LED comes on.
3. Press the SavE button again to disconnect the
function. The green LED goes out. (Fig. 33)
Automatic shutdown function
The product has an automatic shutdown function that
stops the product if it is not used. The green LED for
start/stop indication goes off and the product stops after
45 seconds.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Press the start/stop button until the green LED goes
out.
3. Press the release buttons on the battery and remove
the battery. (Fig. 34)
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
Before
Weekly
Monthly
use
X
X
X
X
X
X
X
X
X
X
X
11