To Operate The Product; Maintenance; Maintenance Schedule - Husqvarna 322HD60 Manual Del Usuario

Ocultar thumbs Ver también para 322HD60:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To operate the product

1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting unit does not move at idle speed.
Do a check of the stop switch. Refer to
6 .
Examine the cutting unit for damages and cracks. Replace if it is damaged.
Examine the hand guard for damages and cracks. Replace if it is damaged.
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
check of the throttle trigger lockout on page 5 .
Examine the engine, the fuel tank and the fuel hose for leaks.
Tighten nuts and screws.
Examine the starter and the starter rope for damages.
Do a check that the screws that hold the blades together are correctly tightened.
Clean the air filter. Clean more frequently if used in areas which has dust. Re-
place if it is damaged.
10
2. Adjust the speed to align with the work load.
3. Hold the product near your body for a stable work
4. Be careful and operate the product slowly.
Maintenance
To do a check of the stop switch on page
WARNING: Make sure that the front of
the cutting equipment does not touch the
ground.
position.
Before
operation
X
X
X
X
To do a
X
X
X
After 40
After 100
h
h
After each operation.
After each operation.
X
X
X
1073 - 004 -

Publicidad

Tabla de contenido
loading

Tabla de contenido