To Adjust The Handle; To Operate The Product; Maintenance; Maintenance Schedule - Husqvarna 122HD45 Manual De Usuario

To adjust the handle

For 122HD60 only:
The rear handle can be adjusted into 5 positions.
• Release the handle lock and turn the handle. (Fig.
22)
To start the product with a cold engine
1. Pull the choke control to choke position. (Fig. 23)
2. Push the air purge bulb approximately 6 times or
until the bulb starts to fill with fuel. It is not necessary
to fill the air purge bulb fully.
3. Hold the body of the product on the ground with your
left hand. Do not step on the product.
4. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force.
WARNING: Do not wind the starter rope
around your hand.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle.
5. Continue to pull the starter rope handle until the
engine fires, then push the choke control to its initial
position.
WARNING: The blades move when the
engine starts.
6. Continue to pull the starter rope handle until the
engines starts.
7. Push and release the throttle trigger to set the
engine to idle speed.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

Maintenance

Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
994 - 002 - 02.07.2019
8. Push the throttle trigger gradually to increase the
engine speed.
9. Make sure that the engine runs smoothly.
To start the product with a warm engine
1. Hold the body of the product on the ground with your
left hand. Do not step on the product.
2. Pull the starter rope handle slowly with your right
hand until you feel some resistance, then pull the
starter rope handle quickly and with force. Continue
until the engine starts.
Note: For more information about how to start the
product, refer to
on page 9 .
To stop the product
• Move the stop switch to the stop position to stop the
engine.

To operate the product

1. Start near the ground and move the product up
along the hedge when you cut the sides. Make sure
that the body of the product does not touch the
hedge. (Fig. 24)
2. Adjust the speed to align with the work load.
3. Hold the product near your body for a stable work
position.
4. Be careful and operate the product slowly.
Maintenance
To start the product with a cold engine
CAUTION: The stop switch automatically
goes back to run position.
WARNING: Make sure that the front of
the cutting equipment does not touch the
ground.
Before After 40
operation h
After each operation.
After each operation.
After 100
h
9