Back View - PEERLESS SmartMount SP850-UNL Instalación Y Montaje

Roll can be adjusted 1° clockwise or
8
counterclockwise.
To adjust roll, loosen M10 x 15 mm screws (K)
slightly, leaving them snug. Level screen and
adapter brackets, then tighten screws (K) .
NOTE: When adjusting roll, screws should be
retightened as indicated in step 4.
SCREEN FASTENER

BACK VIEW

Optional: To lock one sliding arm of mount in place,
10
slide locking tab (B) over top or bottom of sliding
arm and attach to mount using one M5 x 10 mm
screw (AA) and one spacer (C).
Note: Screen not shown for clarity.
NOTE: MOUNTING PLATE SHOWN
WITHOUT FULL WALL MOUNT
ASSEMBLY FOR CLARITY.
AA
B
C
SLIDING ARM
Optional: To lock mount in closed position, insert
9
one M5 x 40 mm screw (DD) into tapped hole in
either top or bottom of flat plate.
Note: Screen not shown for clarity.
TAPPED HOLE
Slide one mesh sleeve (F) over each cable. Use
11
cable ties (G) to tighten both ends of mesh sleeves
to cables.
NOTE: loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
11 of 22
All other brand and product names are trademarks or registered trademarks of their respective owners.
FLAT PLATE
F
G
ISSUED: 4-03-07 SHEET #: 202-9177-5 02-15-10
© 2008, Peerless Industries, Inc. All rights reserved.
DD
TAPPED HOLE
CABLE
MOUNTS