Mounting And Removing Flat Panel Screen - PEERLESS SmartMount SP850-UNL Instalación Y Montaje

• Always use an assistant or mechanical lifting equipment to safely lift and position the plasma television.

Mounting and Removing Flat Panel Screen

Hook adapter brackets (FF or GG) onto adapter plate (EE), then slowly swing screen in as shown. Turn screws
6
clockwise at least six times to prevent screen from being removed as shown in detail 1.
Note: Tighten using 4 mm security allen wrench (M), or 4 mm allen wrench (HH).
Screen can be adjusted horizontally if desired.
NOTE: To lock the screen down, tighten screws to adapter plate as shown in detail 1.
To remove screen from mount, loosen screws, swing screen away from mount, and lift screen off of mount.
EE
SCREWS
ADAPTER
BRACKET
Screen can tilt 5° or 10° forward.
7
NOTE: Screen must be securely attached to mounting plate with all fasteners before adjusting tilt.
To tilt screen 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in figure
7.1. Tighten M6 screw (both sides) and M10 screws (both sides).
To tilt screen 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in figure
7.2. Tighten M6 screw (both sides) and M10 screws (both sides).
NOTE: For security models, tighten M6 screw using security allen wrench (M). For all M10 screws, use 6 mm allen
wrench (not included).
SCREEN
fig. 7.1
DETAIL 1
M6 SCREW
MOUNTING
PLATE
M10 SCREW
5° tilt
WARNING
FF or GG
EE
SCREEN
fig. 7.2
10 of 22
M6 SCREW
MOUNTING
PLATE
M10 SCREW
10° tilt
ISSUED: 4-03-07 SHEET #: 202-9177-5 02-15-10