Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Additional information
Discs to avoid
Discs spin at high speed inside the player. If a
disc is cracked, chipped, warped, or otherwise
damaged, don't risk using it in your player—
you could end up damaging the unit.
This unit is designed for use with conventional,
fully circular discs only. Pioneer disclaims all
liability arising in connection with the use of
shaped discs.
Installation and maintenance
Hints on installation
We want you to enjoy using this system for
years to come, so please bear in mind the
following points when choosing a location:
Do...
Use in a well-ventilated room.
Place on a solid, flat, level surface, such as a
table, shelf or stereo rack
Don't...
Use in a place exposed to high temperatures or
humidity, including near radiators and other
heat-generating appliances.
Place on a window sill or other place where the
system will be exposed to direct sunlight.
Use in an excessively dusty or damp
environment.
Place directly on top of an amplifier, or other
component in your stereo system that becomes
hot in use.
Use near a television or monitor as you may
experience interference—especially if the
television uses an indoor antenna.
Use in a kitchen or other room where the system
may be exposed to smoke or steam.
Use on a thick rug or carpet, or cover with
cloth—this may prevent proper cooling of the
system unit.
Place on an unstable surface, or one that is not
large enough to support all four of the system
unit's feet.
Note
1 Unplugging the unit before Good Bye disappears from the display may cause the system to return to the factory settings.
.
Cleaning the pickup lens
The DVD player's lens should not become dirty
in normal use, but if for some reason it should
malfunction due to dust or dirt, consult your
nearest Pioneer authorized service center.
Although lens cleaners are commercially
available, we do not recommend using them
since some may damage the lens.
Problems with condensation
Condensation may form inside the player if it is
brought into a warm room from outside, or if
the temperature of the room rises quickly.
Although this won't damage the player, it may
temporarily impair performance. You should
leave it to adjust to the warmer temperature for
about an hour before switching on.
Moving the system unit
If you need to move the main unit, first remove
a disc if there's one in the player, then press
STANDBY/ON on the front panel to turn the
system off. Wait for Good Bye to disappear
from the display, then unplug the power cord.
Never lift or move the unit during playback—
discs rotate at high speeds and may damage.
Resetting the system
Use this procedure to reset all system settings
to the factory default.
1
Switch the system into standby.
2
Press and hold the front panel
button for about 8 seconds until the display
shows 'Mem.Clr?'.
3
Press the front panel
All the system's settings are now reset, and
you should see Welcome! in the front panel
display.
10
1
(stop)
button.
41
En
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
