Additional Information; Optional System Settings; System Setup Menu Options In - Pioneer XV-DV333 Manual De Instrucciones

Additional information

Chapter 10
Additional information

Optional system settings

These settings are accessed by using the
System Setup menu while in standby.
1 Switch the system into standby.
2 Press SYSTEM SETUP .
3 Use to choose the setting you want
to adjust then press ENTER .
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
4 Use to adjust the setting.
5 Repeat steps 2 and 3 to make other
settings then press ENTER to confirm.
System Setup menu options in standby
Below are all the available settings in the setup
menu. The first setting in each is the default.
System demo setting
Switches the automatic demo feature on or off
(this starts when you plug in for the first time):
• Demo On – Switches the demo feature on.
• Demo Off – Switches the demo feature off.
Note
1 After setting the clock, the demo mode switches off automatically. However, if you unplug the system from the wall outlet, the
demo mode will revert to Demo On (and the clock will be reset).
Key lock setting
The Key Lock feature is useful when you've set
the wake-up timer and don't want the system
switched on before it activates.
• Lock On – Makes the front panel buttons
and controls inoperative.
• Lock Off – Restores regular use of the
front panel buttons and controls.
Clock format setting
Specifies how the clock is displayed:
• 12-Hour – Display shows 12-hour format.
• 24-Hour – Display shows 24-hour format.
TV / Line attenuator settings
If the source connected to the analog TV IN
input (TV) or LINE1 input (L1) is distorting, the
attenuator will reduce the signal level.
• ATT 6dB – Reduces signal level by 6dB.
• ATT 10dB – Reduces signal level by 10dB.
• ATT Off – No attenuation
1
Frequency step setting
If you find that you can't tune into stations
successfully, the frequency step may not be
suitable for your country/region.
• AM 9K
• AM 10K
TV system setting
The default setting of this system is AUTO, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO. If you find picture distortion with
some discs, set the TV system to match your
10
37
En