Master Forge 1010048 Manual Del Usuario página 16

17. Attach the side burner valve
A. Loosen but do not remove the two pre-
installed screws from the side burner valve.
B. Insert the side burner valve screws
through the keyhole slots in the front of the
side burner shelf and then slide the valve
upward so the screws rest in the small
section of the keyhole slots.
C. Place the side burner knob bezel (X)
keyhole slots over the side burner valve
screws. Let the bezel slide down so that
the screws rest in the small section of the
keyhole slots and then tighten the screws.
Shown in Fig. 17.
18. Install the side burner
A. Remove the side burner cooking grate
and then insert the side burner (C1) into
side burner tray and slide the burner tube
over the side burner valve. Secure in place
using two 5/32-32 x 3/8 in. screws AA).
Shown in Fig. 13A. Reinstall the side
burner cooking grate. Shown in Fig. 18.
Hardware Used
5/32-32 x 3/8 in.
AA
Screw
19.
Assemble the electronic ignition
wire
B. Attach the electronic ignition wire to the
side burner electrode located under the
side burner shelf as shown in Fig. 19.
x 2
16
17
18
19
lowes.com/masterforge
X
C1
AA
®