Cleaning The Enclosure; Replacing The Strobe Tube - Federal Signal Global G-STR Instrucciones De Instalación Y Mantenimiento

Installation and Maintenance Instructions

Cleaning the Enclosure

The enclosure should be cleaned periodically with a damp cloth to maintain
maximum light output. The polycarbonate colored strobe lens should be
regularly inspected for cracks. If it is damaged, it must be replaced.
Refer to the "Certification" section on page 6 for any applicable Specific
Conditions of Use.

Replacing the Strobe Tube

EXPLOSION HAZARD: To maintain the flameproof integrity of the
enclosure, DO NOT damage the lens or threads while disassembling or
reassembling the beacon.
LIGHT HAZARD: To be an effective warning device, the beacon
produces bright light that can be hazardous to your eyesight when
viewed at close range. Do not stare directly into the beacon at close
range or permanent damage to your eyesight may occur.
BURN HAZARD: The strobe tube gets hot enough to burn you. Always
allow the strobe to cool before handling it.
DO NOT TOUCH STROBE TUBES WITH BARE HANDS: Oil deposits on
the glass portion of the tube can cause the glass to fracture during use.
If you are unsure whether the glass portion has been handled without
gloves, clean the glass using a soft cloth and isopropyl alcohol before
installing the lamp.
STATIC SENSITIVE DEVICE: The circuitry of the beacon can
be damaged by an electrostatic discharge (ESD). Always follow anti-
static procedures while servicing the beacon.
18
Model G-STR Global Series Strobe Beacon