Cleaning The Enclosure; Replacing The Led Array - Federal Signal Global Serie Instrucciones De Instalación Y Mantenimiento

Cleaning the Enclosure

The enclosure should be cleaned periodically with a damp cloth to maintain
maximum light output. The polycarbonate colored LED lens should be
regularly inspected for cracks. If it is damaged, it must be
to the "Certification" section on page 6 for any applicable Specific
Conditions of Use.

Replacing the LED Array

EXPLOSION HAZARD: To maintain the flameproof integrity of
the enclosure, DO NOT damage the lens cover, or threads while
disassembling or reassembling the beacon.
LIGHT HAZARD: To be an effective warning device, the beacon
produces bright light that can be hazardous to your eyesight when
viewed at close range. Do not stare directly into the beacon at close
range or permanent damage to your eyesight may occur.
Federal Signal LED array part No. K859500823-*
BURN HAZARD: The LED array gets hot enough to burn you. Always
allow the array to cool before handling it.
STATIC SENSITIVE DEVICE: The circuitry of the beacon can be
damaged by an electrostatic discharge (ESD). Always follow anti-static
procedures while servicing the beacon.
Tools and replacement part needed:
• 1.5 mm A/F hexagon key
• No. 1 Phillips screwdriver
• Federal Signal LED array part no. K859500823-*.
Model G-LED Global Series LED Beacon
Installation and Maintenance Instructions
replaced. Refer
21