Silverline 261884 Manual Del Usuario página 7

261884
• Clean the tool casing with a soft damp cloth using a mild detergent. DO
NOT use alcohol, petrol or strong cleaning agents
• NEVER use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable
spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure,
or visible sparking
• To replace the brushes, remove the Brush Access Plugs (4) from both
sides of the machine. Remove the worn brushes and replaced with new.
Replace brush access plugs. Alternatively, have the machine serviced at
an authorised Silverline service centre
Note: One set of spare brushes is supplied with this tool.
Hook and loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter,
such as hair, fibres, sand etc.
• In order to provide adequate adhesion for securing accessories, hook and
loop surfaces must be in good condition
• When used extensively, hooks and loops will become elongated or
broken, and the mechanism cannot provide the required strength of
adhesion anymore
Note: This polisher's Hook & Loop Backing Pad (2) is NOT a warranty item.
Replacements can be obtained from www.toolsparesonline.com.
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
• Dispose of polishing compounds and used polishing sponges/bonnets
according to the compound manufacturer's recommendations
www.silverlinetools.com
1010W Polisher
7