Connecting A Turntable; Connecting A Recording Component - Yamaha C-5000 Manual De Instrucciones

Connecting a turntable

Connect your turntable to the PHONO jacks on this unit.
The unit provides XLR-type balanced jacks and RCA-
type unbalanced input jacks.
Balanced connection
Turntable
L
OUTPUT
（BALANCE）
R
Unbalanced connection
Turntable
L
OUTPUT
R
Note
If you connect the turntable to the RCA jacks on this unit,
listen to and compare the sound with the SIGNAL GND
(ground) terminal connected and unconnected, and then
select whichever less noisy .
NOTICE
Do not use balanced and unbalanced connections between
this unit and the turntable simultaneously . Doing so would
create a ground loop that could generate static and noise .
22
Connecting a recording
component
You can connect a recording device, such as a hard disk
recorder to the unit, and record audio input from the unit.
Connect the recording component to both LINE 2 IN
jacks and LINE 2 OUT (recording) jacks.
Note
• Make sure that you connect the LINE 2 IN jacks and LINE
2 OUT (recording) jacks to the same component .
• The signal from the LINE 2 OUT (recording) jacks is
essentially identical to the signal from the output jacks
specified by the OUTPUT selector . If the INPUT selector is
set to LINE 2, no signal will be output at the LINE 2 OUT
(recording) jacks .
Hard disk recorder,
etc
L
OUTPUT
R
L
INPUT
R