Movement Idea ABDUCTION Manual Del Usuario página 89

MAINTENANCE
7
TOP PLATE
Allows the weight to be selected. At the slightest damage or wear the parts does not try to select
the weight. Contact Techinical Assistance to make the change
LOCKING STEEL CABLE
Always check that the screws are securely fastened to the plates. If the locks are damaged, do
not allow the equipment to be used. Contact Technical Assistance to make the change.
SNAP LINK
Some models use snap link , so it is extremely important to check the condition of the carabiner.
At the slightest sign of wear, deformation, difficulty to close and anything that could be
detrimental to its resistance, replace the snap link immediately
REPLACEMENT CARABINER
For the replacement, always use a snap link supplied directly by MOVEMENT. If it is not possible
to obtain a snap link supplied by MOVEMENT, use a snap link that strictly meets the following
requirements.
-Material composition: Stainless steel AISI 316;
- Maximum closed capacity: 1600kg;
- Maximum open capacity: 350kg
-Monthly, verify with attention the conditions
of the snap link ;
- Do not modify the snap link in any way;
- The opening of the snap link must be
ATTENTION!
turned to the weights column.
ARM CONNECTION
The gas spring is located between the leg support, if it is difficult to adjust the spring to gas,
difficult to move the legs, a gas spring that prevents movement of the legs or damages its
structure, contact your nearest service center.
STEEL CABLE
During the equipment use the cable may be damaged for misuse or lack of maintenance.
Sometimes the steel cable can be damaged even if it is not shown if it is damaged. Stay alert and
always observe any kind of problem as a cable. Do not use and do not allow the equipment to be
used if the steel cable is damaged. Below are some examples of damaged steel cable.
41