Description And Specifications; Engineering Data; Piping; Wiring And Grounding - Xylem GOULDS VB Serie Instrucciones De Instalación, Operación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DESCRIPTION AND SPECIFICATIONS

The VB Series is a high pressure pump used for coolant
circulating systems.

ENGINEERING DATA

• Maximum Liquid Temperatures: 160°F (72°C)
• Maximum Suction Pressure 75 psi
• Pipe connections are 1" NPT suction and discharge.
¾" Hose Adapters are available.
• Capacities to 33 GPM
• Heads to 600 Feet (260) psi
• Rotation: Left hand, ie; COUNTERCLOCKWISE
when viewed from motor end.

PIPING

• Piping should be no smaller than the pump discharge.
Piping should be kept as short as possible, avoiding
unnecessary fittings to minimize friction losses.
• All piping MUST be independently supported and
MUST NOT place any piping loads on the pump.
• All joints MUST be airtight. Use 3 – 4 wraps of PTFE
tape to seal threaded connections.

WIRING AND GROUNDING

Install ground and wire according to
WARNING
local and National Electrical Code
requirements.
Install an all leg disconnect switch
near the pump.
Disconnect and lockout electrical
Hazardous voltage
supply before installing or servicing
can shock, burn or
cause death.
pump.
Electrical supply MUST match pump's name plate
specifications. Incorrect voltage can cause fire and/or
damage to the motor and voids warranty.
Motors not protected MUST be provided with con-
tactors and thermal overloads on single phase mo-
tors, or starters with heaters on three phase motors.
See motor nameplate.
Use only stranded copper wire to motor and ground.
The ground wire MUST be at least as large as the wire
to the motor. Wires should be color coded for ease of
maintenance.
Follow motor manufacturer's wiring diagram on the
motor nameplate or terminal cover carefully.
FAILURE TO PERMANENTLY
WARNING
GROUND THE PUMP, MOTOR AND
Hazardous
CONTROLS BEFORE CONNECTING
voltage
TO ELECTRICAL POWER CAN
CAUSE SHOCK, BURNS OR DEATH.

ROTATION

NOTICE: INCORRECT ROTATION MAY CAUSE
DAMAGE TO PUMP AND VOIDS THE
WARRANTY.
Correct rotation is left-hand, COUNTER-CLOCK-
WISE when viewed from the motor end.
To reverse three phase motor rotation interchange any
two power supply leads.

INSTALLATION

Minimum and maximum liquid levels must be main-
tained for proper pump operation. See Figure 1.
Allow adequate space for servicing and ventilation.
Protect from freezing or flooding.
1" NPT PORT
(DISCHARGE)
3¼" MIN.
1" NPT PORT
(SUCTION)
BOTTOM OF TANK
Figure 1

OPERATION

SPLASHING OR IMMERSING OPEN
WARNING
DRIP PROOF MOTORS IN FLUIDS CAN
Hazardous
SHORT OUT MOTOR AND CAUSE
voltage
FIRE, SHOCK, BURNS OR DEATH.
NOTICE: PUMP MUST BE FULLY PRIMED BEFORE
OPERATION. DO NOT RUN PUMP DRY.
After stabilizing the system at normal operating con-
ditions, check the piping. If necessary, adjust the pipe
supports.
Do not run pump dry; damage to
CAUTION
mechanical seal will result. Do not run
against closed nozzle for prolonged
periods or damage to pump and piping
will result.
NON-FOOTED MOTOR
¼" NPT PLUG
WATER LEVEL
5" MIN.
2" MIN.
3

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido