EN
54
3. The display will show "Network wizard scanning....". Your radio will
now scan for your wireless network, this may take a few seconds then
a list of all the wireless networks will appear on the screen. Press the
/ buttons on unit or
your wireless network, then press the SELECT button on unit or remote
control to confirm.
4. Press the / buttons on unit or
select Push Button/Pin/ Skip WPS, then press the SELECT button on unit
or remote control to confirm.
Connecting using the WPS button on your router
Connecting using the WPS (Wi-Fi Protected Setup) button on your router
is a quick and easy way to connect your radio without having to type in a
password.
If your router has a WPS button you will notice [WPS] at the front of your
network name.
5. Press the / buttons on unit or
select Push Button, then press the SELECT button on unit or remote
control to confirm.
6. You will now see a message on the screen telling you to press the WPS
button on your router. Press the WPS button on your router. Check your
routers instruction manual if you are unsure which button is the WPS
button.
7. Press the SELECT button on unit or remote control to confirm. Your radio
will now connect to your router, this may take a few seconds.
Connecting using your wireless network password
If your router has not got a WPS button you will now be asked to enter your
wireless network password, or you can select SKIP WPS which also take you
to the password screen.
8. Press the / buttons on unit or
select each letter/ number of your password. Then press the SELECT
button on unit or remote control to enter the selected letter/number.
9. When you have entered your password, press the
control, to select „OK" on the right of the display.
10. After your radio has connected, press the SELECT button on unit or
remote control to exit the setup.
/
buttons on remote control to select
/
buttons on remote control to
/
buttons on remote control to
/
buttons on remote control to
/
on the remote