Start - auna Connect Vertical Manual Del Usuario

EN
52

START

Powering ON/OFF
When you first connect the unit to the mains socket, the unit will be in
Standby mode after showing the welcome screen
1. Press the STANDBY/ON button on unit or the on the remote control to
switch the unit on.
2. Press the STANDBY/ON button on unit or the q button on remote
control to switch the unit back to standby mode.
When you first connect the unit to the mains socket, the Initial Set-Up
wizard starts, you can run through this to configure settings for date/time
and network. Once this has finished, your radio is ready to use. (Please refer
to Initial Set-Up section for details)
Selecting modes
Press MODE repeatedly on the unit or on the remote to switch between
Internet radio, Podcasts, Spotify,
DAB, FM, CD, USB, BT and AUX in modes.
Alternatively,:
1. Press and hold the INFO/MENU button on the unit or press the MENU
button on remote control to access the menu.
2. Press the / buttons on unit or press
to select the main menu, then press the SELECT button on unit or remote
control to confirm.
3. Press the / buttons on unit or press
to select the target mode, then press the SELECT button on unit or
remote control to confirm.
When the unit is idle for approximately 15 minutes, it will automatically
switch to standby. To switch the unit off completely, remove the mains plug
from the main socket. Please turn the unit off completely to save energy
when not in use.
Navigating the menu
1. Press and hold the INFO/MENU button on the unit or press the MENU
button on the remote to access the menu.
2. Press the / buttons on unit or press
to select your choice.
3. Press the SELECT button on unit or remote control to confirm your
selection.
/ buttons on remote control
 
/ buttons on remote control
 
/ buttons on remote control
 