Klarstein Iceberg Breeze Manual Del Usuario página 40

EN
40
The appliance is running,
but there is no air cooling
or pump operation.
Water is leaking.
The water tank cannot be
inserted.
The swing function is not
working.
The appliance is loud or
vibrates.
The appliance does not
respond to the infrared
remote control.
Note: Wait for at least 3 minutes after maintenance work. Only then switch the
appliance back on.
Check whether cooling mode is activated. The
LED indicator for the cooling mode (22) should be
illuminated.
Check the filling level of the water tank (see section
"Filling the water tank"). The LED indicator for the
cooling mode (22) should not flash.
Check whether there are any objects blocking the pump
inlet. Make sure that the pump inlet is not blocked.
In case the pump does not operate despite a correctly
filled water tank and activated air cooling mode, the
pump might be defective. Contact the customer service.
Check the appliance for leaks.
Check the water tank for tight fit.
Check whether the mechanism for lowering the pump
was released. If the pump can be seen in the lower
area, the water tank is being blocked. Push the pump up
until the switch for lowering the pump can be seen.
The swing function motor might be defective. Contact
customer service.
Check whether the appliance is set up in a stable and
upright position.
Check whether the distance between remote control
and appliance is too large and reduce it if necessary.
Make sure there are no obstacles, such as furniture or
walls between the appliance and the remote control.
Ensure visual contact between appliance and remote
control.
Check the charging status of the batteries and change
them if required.
If the batteries have just been replaced, check that they
are inserted correctly according to the polarity (+/-).