Getting Started - Elcometer 130 Guia Del Usuario

3 GETTING STARTED

3.1 SELECTING YOUR LANGUAGE
1 Press and hold the ON/OFF button until the Elcometer logo is displayed
2 Press Menu/Setup/Language and select your language using the
softkeys
3 Follow the on screen menus
To access the language menu when in a foreign language:
1 Switch the gauge OFF
2 Press and hold the left softkey and switch the gauge ON
3 Select your language using the
3.2 SELECTING THE MEASUREMENT MODE (MODEL T)
The Elcometer 130 can be used to measure soluble salts (Model S & T) or conductivity (Model T).
To select the measurement mode (Model T), press Menu/Setup/Measurement Mode.
3.3 SELECTING THE MEASUREMENT UNITS (MODEL T)
Whilst the Elcometer 130 Model S provides readings in µg/cm , the Model T has a choice of
measurement units:
Surface Cleanliness Mode:
Conductivity Mode:
To select the measurement units (Model T), press Menu/Setup/Units.
†
Default setting
www.elcometer.com
é
softkeys
ê
2† 2
µg/cm or mg/m
†
µS/cm , mS/cm, ppm or % Salinity
é
ê
2
R
4